Clamp for Danish S-Tine to Fit on a 2”x 2” Toolbar
Clamp for Danish S-Tine to Fit on a 2”x 2” Toolbar on a 3 Pt. Hitch
The clamp will attach an S-Tine (shown below, not included) to a 2 x 2 toolbar.
S-Tines - Also known as Danish Tines (Sold Separately)
Also available at checkout are the following sweeps and bolts to build your cultivator.
76A380 Sweep 1 (Not Included)
76A381 Sweep 2 3/4 (Not Included)
76A382 Sweep 4 (Not Included)
76A383 Sweep 7 (Not Included)
7A9080 Bolts to Attach Sweeps to S-tines (Sold Separately)
HT02-04-L4 2 x 2 Toolbar for a 3 Point Hitch (Sold Separately)
3 Pt. Hitch Above (Sold Separately)
Suggested Setup in Pics Below:
Snug up Elliptical Bolts on S-Tines with 9/16” wrench
You will need 3/8” x 3 Carriage bolts for S-Tine Clamps and 7/16” Nuts to fasten the S-Tine Clamps to the Toolbar
11/16” Wrench to snug up the bolts on the S-Tine Clamps