CAT 1 Bolt on 3 Pt. Hitch for 2 x 2 Toolbar, Includes Pins
Build Your Own Disc Hiller & Furrower, Cultivator, Middlebuster and So Much More with a Cat 1 3 Pt. Hitch for a 2 x 2 Toolbar!
Woodward Crossings' Wunderbar 3 Pt. Hitch ToolKit --Because it's Marvelously Wonderful!
With Just 1 Hitch and a Toolbar,
You Can Build Many Implements!
Heavy Duty - Up to 85 HP
Cat I Hitch Pins:
WUNDERBAR 3 PT. HITCH DIMENSIONS:
17" from Top Pin to Lower Pin
Upper Link is 3/4"
Lower Links are 7/8"
Pin to Pin - Center to Center - 26"-28"
Recommended for Use with our Components or Components that a Similar in Size and Function
3 Pt. Hitch Can Ship FedEx Ground
Pictured with a 2 x 2 Toolbar (Sold Separately)
Snug up Toolbar on the 3 Pt. Hitch with a 1 5/16" Air Ratchet
HT02-04-L4 2 x 2 Toolbar for a Three Point Hitch (Sold Separately)
It's All About Versatility!
Wowsers! Above is a pic submitted by David Mastin of New York.
Showing our CAT I 3 Pt. Hitch, 18" Spacers, 6 Ft. Toolbars, our 5/8" Shanks, and Straight Chisel Spikes.
David painted his toolbars John Deere Green. Quite impressive! Thanks, Dave for Sharing!
One Toolbar, One Hitch and Create Many Implements in Just a Few Minutes!
Dig Potatoes by Adding a Shank, Shank Clamp and a High Sweep Furrower
Cultivate Crops by adding S-Tines, S-Tine Clamps and Sweeps
Hill Potatoes & Build Rows to Keep Dirt Close to Crops by Adding Disc Hillers and Disc Hiller Clamps
By using 2 "Spacer Bars" and Adding an Additional Toolbar
You Can Make Your Own 2-Row Cultivator and More!
Spacer Bars, Toolbars & Attachments Sold Separately
More Tillage Options Below:
Email us the part numbers desired for price quote and availability:
1 5/16” Socket to snug up the Toolbar on the 3 Pt. Hitch
1 1/8 Socket to snug up the Disc Hiller Clamps to the toolbar
9/16” wrench to tighten up the Disc Hillers in the Disc Hiller Clamp
5/8” Wrench to snug up Flat Shank to the Flat Shank Clamp
¾” Wrench to snug up Flat Shank Foot Pieces
(2) 3/8” x 3” bolts and washers to affix the Furrower to the Foot Piece
9/16” Wrench to snug up the bolts to Foot Piece and Furrower
Snug up Elliptical Bolts on S-Tines with 9/16” wrench
3/8” x 3 Carriage bolts for S-Tine Clamps and 7/16” Nuts to fasten the S-Tine Clamps to the Toolbar
11/16” wrench to snug up the bolts on the S-Tine Clamps
Pictured above is our CAT I Hitch, (4) Disc Hillers w/Round Shank Clamps on a 2 Row Toolbar Setup w/ Spacer Bars & Gauge Wheels